Ceiling fan harbor breeze mayfield.
Instll a ceiling fan wall mount.
Share it with us.
If your ceiling is 9 feet or higher choose a 5 foot stepladder.
Step 7 install the canopy.
Wall mounted or table fan.
The ceiling plate or fan bracket is the fixture that your fan will be suspended from.
In order to install your ceiling fan on an angled ceiling you will need to purchase a longer downrod sold separately.
If your ceiling is 12 feet or higher choose an 8 foot stepladder.
Make sure that the wire is not hanging too low between hooks.
Depending on the angle of the ceiling and your fan type you may also need an angled ceiling mount adapter.
Attach the ceiling plate or bracket.
Wiring will vary according the manufacturer.
Run the wires on one side of the pin in the downrod ball.
For added electrical safety flip the breaker switch and turn off the main power supply.
This is for obvious safety as well as give it the best air flow.
At the end of the day you ll want a ceiling fan that hangs down no lower than 7 feet and the edge of the blades are at minimum a few feet from the edges of the wall.
Ladder use a ladder to reach the mounting bracket and hang the motor assembly as well as wire the ceiling fan.
Use the handle to mount on the wall with the two included wall brackets or simply use the sturdy handle for stabilizing on tables.
Versatile in design the fan can either be used as a tabletop or wall mount fan.
Be the first to share did you make this project.
For a fan with a downrod thread the wires through the canopy trim ring if applicable canopy and downrod.
Turn the wall switch to the off position.
Use a step ladder to reach the base of the fan.
Hold the ceiling plate up to the fan box and pull all of the wires through the hole in its center.
Now i have a wall mounted fan that helps keep cool this tiny room i tend to spend some time in.
Add tip ask question comment download.
I wired the supply in the ceiling.
When you install a hook hang a link of chain on it to view your progress.
Install the wireless ceiling fan control receiver into the base.
First make sure your ceiling fan can be installed on angled ceilings.
Use the provided screws to tightly secure the ceiling plate in place.
Install the ceiling hooks in a direct line toward the outlet you will be using.
Use electrical tape to insulate all wire connections.
The assembly slid onto the horizontally mounted shaft.
For a flush mount fan thread the wires from the fan motor through the top housing trim ring if applicable and canopy.