Place it across two sawhorses.
Installing window pane in door.
Use a heat gun to soften old glaze.
Scrape excess glazing compound from window pane.
How to glaze a window pane.
Although glazing putty is the best choice for installing a pane of glass you can use latex caulk.
Cut the panel out of the door or a piece the size you require for your window.
Place another sawhorse under the location where the door will be.
To install new glass on a mid view door retract the finger pulls of the bottom panel as you slide it into place before release.
Glue the molding or nail it into place on one side of the door.
Press in new glazing points every 10 inches with the tip of a putty knife.
Carefully lay the glass in place add another bead of caulk around the inside of the glass and frame around the hole on the other side with the decorative moulding.
Wiggle the pane into the putty while applying even pressure with the tips of your fingers.
Retract the finger pulls and push the insert through the notch.
Finish the corners with a handsaw.
Caulk is easier to use than putty but it will shrink which can loosen the glass and it won t.
Once one side is secured flip the door over and lay a bead of caulk around the inside of the moulding.
Insert new pane of glass.
Place one clamp on the door at each sawhorse.
Glazed window pane is now ready for paint.
Apply glazing compound with a putty knife.
If you are installing glass in a door i would strongly recommend getting a piece that is to 3 8 thick and tempered tempered glass is about 4x stronger than plain glass and if shattered it breaks into a bunch of tiny relatively harmless pieces vs.
If any voids show under the glass pull out the pane add more putty and start over.
Press the new window glass lightly to bed it.
Sand the edges of the opening with medium grit sandpaper to make it smooth.
Http bit ly 1hmtbbx watch more mr.
How to put a window in a solid wood door step 1.
Continue pushing down until the glass is centered in the opening and about 1 8 inch of putty remains between the face of the glass and the rabbet.
With the help of a friend set the new window glass in place.
The super sharp shards of regular glass.
Remove the door from the hinges using a drill driver.
You can then scrape old glaze off with a painters knife.