Use metal 1 inch roofing nails to install the metal edging that goes around the perimeter of the roof.
Installing metal roofing on a flat roof.
Sunday august 5 2018 the traditional metal roof types such as 5v crimp shown above and corrugated are rated by the manufacturers for use down to a 3 12 pitch three inches of vertical rise for every foot of horizontal run.
For exposed fasteners avoid over tightening the fastener.
Metal is one of the most durable roofing material to install however the initial investment is much higher up front than other commercial and flat roofing solutions.
In a standing seam roof long single panels run vertically all the way from the eave to the ridge.
Be sure the larger edge is laid so that the small edge of the next panel will overlap it.
Align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof.
Take a metal sheet and use inch metal wood screws to affix the roofing onto the wood slats.
You can use 1 inch nails for the installation of eave flashing.
Next you are ready to install the metal roof.
Make sure that the screws are all aligned evenly as you will be able to see them from the ground if they are.
Metal has quickly become the standard roofing material for commercial and flat roofing systems and for good reason.
Can metal roofing be used on a low slope pitch roof.
The metal roofing will be installed onto the top of the boards.
Install the roofing screws vertically along each rib in the panel.
The eave flashing or edging is just the steel metal strips used to cover the entire perimeter of the roof.
They need to be about every 2 feet apart.
Space the screws about 12 in 30 cm apart.
Step 3 install the metal edging.
Place the first screw.