So if you upgraded your overhead door garage door opener to a genie opener then you are in luck.
Installing genie garage door opener safety sensors.
Replace with the new genie garage door sensors.
Installing the sensors as part of the garage door opener installation requires attention to wiring and adjustments to the devices themselves.
1 push the safety sensor with attached carriage bolt.
However genie uses clips to secure the wires to the opener rail rather than stapling the wires to the ceiling.
Fasten to header and wall preferably with insulated staples.
These comes with the wall attachment already on.
Similarly the genie brand is owned by overhead door so genie s safe t beam sensor also on amazon is the same sensor used for both genie and overhead door garage door openers.
The convenient video features step by step directions for installing genie garage door opener models 2055 and 7055.
Genies safe t beam system is designed to ensure maximum safety for your garage door opener operation.
You can use this video for other genie garage door openers that use the same tube rail that are belt or chain models as well.
Wiring a sensor for a genie garage door opener is much like any other opener.
If this was not available and did not accept a gdo safety beam sensor it is trivial to control the opener with an arduino and end stop switch to let the arduino know that the garage door is in the down position and a relay to trigger the door open close.
Allow for some slack at the source and sensor units and cut off any excess wire.
The newest style genie garage door openers that have tube rails are made for easy diy installation.
At source and sensor route wires through bracket as shown and attach wires at terminals.
Either wire to either terminal non polar.
Hook the wires under the flat square and tighten.